Installation - Beko CTB 6250 W Manual De Instrucciones

3

Installation

3.1 Drilling the Support surface and
Fitting the Hood
Screw Fitting
• The hood support surface must be 135 mm
above the bottom surface of the wall units
• Drill the support with a ø 4,5 mm drill bit, using
the drilling template provided
• Cut a hole ø 120-150 mm in size on the sup-
port surface, using the drilling template provi-
ded
• Fix using the 4 screws 12a (4,2 x 44,4) provi-
ded
8 / 130 EN
Snap-On Fitting
• The hood can be installed either directly on the
bottom surface of the wall units using snap-on
side supports
• Cut a fitted opening in the bottom surface of the
wall unit, as shown
• Insert the hood until the side supports snap into
place
• Lock in position by tightening the screws Vf
from underneath the hood
CTB 6250 W/B/X
Hood Type
L1
CTB 9250 X
510 810
Hood / User Manual