Installation - Beko CTB 6250 W Manual Del Usuario

3

Installation

3.1 Drilling the Support
surface and Fitting the Hood
Screw Fitting
• The hood support surface must be 135 mm
above the bottom surface of the wall units
• Drill the support with a ø 4,5 mm drill bit, using
the drilling template provided
• Cut a hole ø 120-150 mm in size on the support
surface, using the drilling template provided
• Fix using the 4 screws 12a (4,2 x 44,4) provided
Snap-On Fitting
• The hood can be installed either directly on the
bottom surface of the wall units using snap-on
side supports
• Cut a fitted opening in the bottom surface of
the wall unit, as shown
• nsert the hood until the side supports snap into
place
126
8 / EN
All manuals and user guides at all-guides.com
• Lock in position by tightening the screws Vf
Hood Type
L1
from underneath the hood
CTB 6250 W/B/X CTB 9250 X
510 810
Hood / User Manual