SICK GTE6-Line Instrucciones De Operación página 40

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
63
解体および廃棄
8015312 | SICK
Subject to change without notice
LED 表示灯/故障パターン /
LED indicator/fault pattern
緑色の LED が点灯しない /
Green LED does not light up
緑色の LED が点灯しない /
Green LED does not light up
黄色い LED が点滅 /
Yellow LED flashes
黄色い LED が点灯、光軸に
対象物がない /
Yellow LED lights up, no
object in the path of the
beam
対象物は光軸にある、黄色い
LED は点灯しない /
Object is in the path of the
beam, yellow LED does not
light up
対象物は光軸にある、黄色い
LED は点灯しない /
Object is in the path of the
beam, yellow LED does not
light up
センサは必ず該当国の規制にしたがって処分してください。廃棄処理の際には、
できるだけ構成材料をリサイクルするよう努めてください(特に貴金属類)。
原因 /
Cause
電圧がきていない又は不安
定 /
Voltage interruptions
センサの異常 /
Sensor is faulty
センサの動作準備はまだ整
っているが、動作条件が最
適ではない /
Sensor is still ready for ope‐
ration, but the operating
conditions are not ideal
背景からの反射が過剰状態
です /
Remission capability of the
background is excessive
センサの設定感度が低すぎ
るか、またはセンサと対象
物との距離が長すぎる /
Sensitivity is set too low or
distance between the sen‐
sor and the object is too
long
検出対象物の反射率が不十
分 /
Remission capability of the
object is insufficient
63
解体および廃棄
対策 /
Acción
安定した電源電圧が供給さ
れていることを確認します /
Ensure there is a stable
power supply without inter‐
ruptions
電源に問題がなければ、セ
ンサを交換します /
If the power supply is OK,
replace the sensor
動作条件を確認します: 投
光光軸(投光スポット)を
対象物に完全に合わせます /
光学面の洗浄 / 感度を再調
整する(感度調整ボリュー
ム) / 検出距離を点検し必
要に応じて調整する、グラ
フ F 参照。 /
Check the operating condi‐
tions: Fully align the beam
of light (light spot) with the
object. / Clean the optical
surfaces . / Readjust the
sensitivity (potentiometer) /
Check sensing range and
adjust if necessary; see
graphic F.
背景の変更を確認してくだ
さい。センサの感度を下げ
るか、または BGS 機能付き
のセンサを使用してくださ
い /
Check changes to the
background. Reduce the
sensitivity of the sensor or
use sensors with back‐
ground suppression
センサと背景間の距離に注
意して検出距離を拡大しま
す(図 F 参照)。 /
Increase the sensing range,
take note of the distance
between the sensor and the
background, see graphic F
センサと背景間の距離に注
意して検出距離を拡大しま
す(図 F 参照)。 /
Increase the sensing range,
take note of the distance
between the sensor and the
background, see graphic F
39

Publicidad

Tabla de contenido
loading

Tabla de contenido