Uline H-1287 Manual De Instrucciones página 2

Figure 1
MACHINE PLACEMENT
Place the low profile turntable close to an area where
you will be wrapping your pallet loads. Make sure that
there is sufficient room to load/unload the machine and
that you do not stretch the wiring cable. Remember,
you will need to provide electrical service to a 120 VAC,
15-AMP outlet.
FLOOR WEIGHT BEARING TOLERANCE
The floor must be able to bear the weight of the
machine, the weight of the maximum load, plus a
safety factor. The floor must also be able to tolerate
the stress of the machine's operation. If the fork trucks
will operate on the same weight bearing area, add
the weight of the trucks to the weight bearing stress
tolerance requirements.
PAGE 2 OF 21
System Description
52"
14"
3.2"
28"
52"
59"
SYSTEM SET-UP
MACHINE SET-UP
Place skidded machine close to the designated wrap
area. Remove all shipping fasteners holding the ma-
chine to the pallet.
Place forks of the forklift through the tubes provided at
the rear base of the module, remove the machine from
these skids, and place it at the designated wrap area.
95"
Ø59"
0521 IH-1287