Tilt Stand
Tilt stand at 60 º
Safety Notices
A CAUTION notice denotes
CAU TI O N
CAU TI O N
a hazard. It calls attention
to an operating procedure,
practice, or the like that, if
not correctly performed or
adhered to, could result in
damage to the product or
loss of important data. Do
not proceed beyond a
CAUTION notice until the
indicated conditions are
fully understood and met.
A WARNING notice
WA RN ING
denotes a hazard. It calls
attention to an operating
procedure, practice, or the
like that, if not correctly
performed or adhered to,
could result in personal
injury or death. Do not
proceed beyond a
WARNING notice until the
indicated conditions are
fully understood and met.
For further safety information details, refer to the
Agilent U1241B and U1242B Handheld Digital Multimeter
Safety Information
The Agilent U1241B and U1242B are
safety-certified in compliance with the
following safety and EMC requirements:
• IEC 61010-1:2001 / EN61010-1:2001
• USA: UL 61010-1:2004
• Canada: CSA C22.2 No. 61010-1:2004
• IEC 61326-1:2005/ EN 61326-1:2006
• Canada: ICES/NMB-001:2004
• Australia/New Zealand: AS/NZS
Safety Symbols
User's and Service Guide.
Tilt stand at 30 º
CISPR11:2004
Earth (ground) terminal
Equipment protected
throughout by double
insulation or reinforced
insulation
Caution, risk of electric
shock
Caution, risk of danger (refer
to the instrument manual for
specific Warning or Caution
information)
CAT III
Category III 1000 V
overvoltage protection
1000 V
CAT IV
Category IV 600 V
overvoltage protection
600 V