Publicidad
Navodilo za uporabo
1. Set the machine for a 4-thread overlock or a wide 3-
thread overlock (left needle).
1. Nastavite stroj za šivanje s 4-nitnimi overlock šivi
ali širokimi 3-nitnimi overlock šivi (leva igla).
2. Cords/Piping including fabric of up to 1/8" (3 mm)
diameter can used.
2. Možna je uporaba vrvic/paspul s premerom
3. Raise the presser foot and snap on "Piping foot"
največ 3 mm.
3. Dvignite tačko in namestite tačko za
4. Place bias fabric strip around cord, fabric edges to the
right, place under the foot, cord into the groove.
paspuliranje.
5. Lower the foot, sew a few stitches to fix it.
4. Ovijte paspulo okrog vrvice, rob blaga mora biti
na desni, namestite pod tačko, vrvica gre v utor.
6. Raise the presser foot.
5. Spustite tačko in naredite nekaj pritrdilnih šivov.
7. Place the two layers of fabric, right sides towards the
6. Dvignite tačko.
piping.
7. Namestite dve plasti blaga s sprednjo stranjo v
8. Lower the presser foot and sew.
smeri paspule.
8. Spustite tačko in zašijte.
Tačka za paspuliranje – Navodilo za uporabo
Piping foot – Instructions
10
Publicidad
