Cembre B-TC500Y Manual De Uso Y Mantenimiento página 6

This tool has been speci cally designed for cutting Copper, Aluminium and ACSR conductors.
DO NOT ATTEMPT TO CUT STEEL ROPES, GUY WIRE OR EARTHING ROD.
Do not use the tool for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be careful to maintain a
balanced working position.
Work in a clean, uncluttered area. Keep persons away from immediate work area.
Inspect the blades before each use. Do not use damaged blades.
Damaged blades can break and cause injury or damage to the tool.
Before each use, verify the integrity of the tool; replace any worn, possibly damaged or missing
parts with original Cembre spares.
Wear eye protection. Metal chips can y from blades when cutting.
Do not cut live cables or conductors.
The tool is unsuitable for continuous use and should be allowed to cool down following uninter-
rupted, successive cutting operations; for instance, having exhausted a fully charged battery in
one session, delay battery replacement for a few minutes.
Protect the tool from rain and moisture. Water will damage the tool and battery.
Electro-hydraulic tools should not be operated in pouring rain.
The part reference includes the following (Ref. to Fig. 7):
Hydraulic cutting tool
Li-Ion rechargeable battery (2 pcs)
Battery charger (model depends on the tool version)
Shoulder strap
Plastic carrying case
2. INSTRUCTIONS FOR USE
The tool can be easily carried using either the handle or the shoulder strap attached to ring (11)
(Ref. to Fig. 5).
Before starting any work, check the battery charge (Ref. to § 2.7) and recharge if necessary,
following the instructions in the battery charger user manual.
WARNING
6