Memorizing the Channels
Your TV can memorize and store all of the available channels for both "off-air" (antenna) and "cable" channels. After the available chan-
nels are memorized, use the CH
the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and
adding and deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the
TV (i.e. an antenna or a cable system).
Storing Channels in Memory (Automatic Method)
or CH
buttons to scan through the channels. This eliminates the need to change channels by entering
1. Press the MENU button to display the menu.
Press the
or
ENTER
button.
2. Press the ENTER
through these choices: "Air", "STD", "HRC", or "IRC" (all cable TV).
Press the EXIT button to exit.
STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system that exists in
your particular area.
At this point, the signal source has been selected. Proceed to "Storing Channels
Automatically".
1. First, select the correct signal source (Air, STD, HRC, or IRC).
2. Press the
or
3. Press the ENTER
The TV will begin memorizing all of the available channels.
The TV automatically cycles through all of the available channels and stores them in
memory. This takes about one to two minutes. Press the ENTER
interrupt the memorization process and return to the "Channel" menu.
4. After all the available channels are stored, the
"Channel" menu reappears. Press the EXIT button to exit.
To stop the search before it has finished, press the ENTER
English-16
buttons to select "Channel", then press the
button. Repeatedly press the
buttons to select "Auto Program", then press the ENTER
button to select "Start".
or
buttons to cycle
button.
button at any time to
button with "Stop" selected.