All manuals and user guides at all-guides.com
O
P E R AT I O N
Memorizing the Channels
Your TV can memorize and store all of the available channels for both "off-air" (antenna)
and cable channels. After the available channels are memorized, use the CH
buttons to scan through the channels. This eliminates the need to change channels by
entering the channel digits. There are three steps for memorizing channels: selecting a
broadcast source, memorizing the channels (automatic) and adding and deleting channels
(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e. an antenna or a cable system).
1
Press the MENU
button
to display the menu.
Press the UP/DOWN
buttons to select "Channel",
then press the ENTER
button.
2
Press the ENTER
button.
Repeatedly press the
UP/DOWN
buttons to
cycle through these choices:
"Air", "STD", "HRC", or
"IRC" (all cable TV), then
press the ENTER
button.
Press the EXIT button to exit.
Note: STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable
system that exists in your particular area.
At this point, the signal source has been selected.
Proceed to "Storing Channels in Memory" (next page).
24
English-
and CH