Product Description; Specifications - Shindaiwa T222 Manual Del Propietario - Operador

Product Description

Using the accompanying illustrations as
a guide, familiarize yourself with this unit
and its various components. See Figure 4.
Understanding your unit helps ensure top
performance, long service life, and safer
operation.
WARNING!
Do not make unauthorized
modifications or alterations to any of
these units or their components.
IMPORTANT!
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal operation.

Specifications

T dry weight
(less cutting attachment) ...........................................10.8 lb./4.9 kg
F dry weight
(less cutting attachment) ...........................................10.8 lb./4.9 kg
Engine model ........................................................................... SE
Engine type ................................................................-cycle catalyst
Bore x stroke ............................................. 1.3 x 1.1 in./33 x 8 mm
Displacement ........................................................ 1.5 cu. in./3.9 cc
Maximum power .......................................................... 1 HP/0.8 kW
Fuel/oil ratio .............................. 50:1 with ISO-L-EGD or JASO FC
Carburetor type ...........................................TK TZ, diaphragm-type
Fuel tank capacity .................................................... 1.0 oz./60 ml
Specifications are subject to change without notice.
This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
Gear case
Trimmer
Head
Shaft case
Figure 4
@ 8000 rpm (min )
-1
class -cycle mixing oil*
■
Engine and shaft assembly
■
Cutting attachment shield
■
Cutting attachment
■
Kit containing cutting attachment shield,
mounting bracket and hardware, this
owner's/operator's manual and tool
kit for routine maintenance. Tool kits
vary by model and may include a spark
plug/screwdriver combination wrench,
and a scraper.
Handle
Outer Tube
Cutting
Attachment Shield
Handle
Outer Tube
Cutting
Attachment Shield
Trimmer Head
Ignition ........................ One-piece electronic, transistor-controlled
Spark plug ............................................................................BPMR6A
Air cleaner type ........................ Non-reversible foam filter element
Starting method ....................................................................... Recoil
Stopping method ............................................................ Slide switch
Transmission type ............................. Automatic, centrifugal clutch
EPA Emission Compliance Period** ........................... Category B
** The EPA emission compliance referred to on the emission compliance label
located on the engine, indicates the number of operating hours for which the
engine has been shown to meet Federal emission requirements. Category
C = 50 hours (Moderate), B = 15 hours (Intermediate) and A = 300 hours
(Extended).
*meets or exceeds these specifications and is
recommended for all Shindaiwa products.
T222
Ignition
Grip
Switch
Throttle
Trigger
F222
Grip
Ignition
Switch
Throttle
Trigger
w/bevel gear
Fuel
Tank
Fuel
Tank
5