Ibanez MiMX30 Manual De Instrucciones página 19

Troubleshooting
First check that your shielded guitar cable, speaker cable, and power cable are
connected correctly. If possible, use a tester to check the cable or try using an
alternate cable or amp to verify your cable's condition.
1. The power supply cannot be switched on.
• Check that the power cable has been connected correctly.
• Try plugging it into a different socket and see if the same problem occurs.
2. The power supply can be switched on, but no sound is
heard.
• Check that the guitar has been connected correctly.
• Remove any external components connected to the effects loop and between
the guitar and the amplifier and check to see if any sound is heard.
• Use a different shielded cable and check to see if any sound is heard.
• Check to see if the volume on the guitar is set to "0".
• Use a different guitar and see if any sound is heard.
• Check to see if the volume on the amplifier is set to "0".
• Check to see if the headphones are connected.
• Is there still no sound when you raise the master volume?
• Check to see if you're using the separately sold IFC2 foot controller as a vol-
ume pedal, and the pedal is in the fully returned position (toward yourself).
3. Noise is heard.
• Check to see if anything in the immediate vicinity is resonating or banging
against the amplifier to produce the noise.
• Check to see if the plug cover on the shielded cable is loose.
• Make sure that the action (string height) of your guitar is set correctly.
• Use another guitar, effects or other external components, and cable to see if
the same noise is produced.
4. No sound when you connect a CD.
• Make sure that the volume of the CD player is not turned to 0.
• Make sure that the cable is connected correctly.
• Try using another cable and see whether any sound is heard.
5. The CD sounds wrong.
Does the cable you're using have a stereo plug? Could you be using a monaural
plug?
6. No sound is produced in the headphones.
• Check that the headphones are connected correctly.
• Connect another set of headphones and see if sound is produced.
7. No drum sounds.
• Check to see if the drum volume is set to 0.
• Check to see if the master volume is set to 0.
• Check to see if headphones are connected.
8. FX Section effect is not applied
• Check to see if the mix level is set to 0.
• Check to see if you're using the tuner built into the MIMX.
9. Delay effect is not applied.
• Check to see if the mix level is set to 0.
• Is there any change when you operate tap?
• Check to see if you're using the tuner built into the MIMX.
10. Reverb effect is not applied.
• Check to see if the mix level is set to 0.
• Check to see if there any change when you operate tap.
• Check to see if you're using the Drum function.
• Check to see if you're using the tuner built into the MIMX.
11. Can't use the foot switch.
• Is the separately sold IFS2M foot switch connected?
In case of defects
This product has passed exhaustive inspections before being shipped from the
factory. Ensure that the above procedures are carried out when a problem is
thought to exist. Contact your dealer in the unlikely event that an abnormality oc-
curs during use. Also, ensure that the symptoms of the problem are explained in
detail when requesting repair in order to facilitate swift handling. Because of im-
provements to this product, the specifications may change without notice.
17