Safety Information; Safety Precautions; External Connections - OHAUS 2000 Serie Manual Del Usuario

2000 SERIES INDICATORS

1. SAFETY INFORMATION

Definition of Signal Warnings and Symbols
WARNING
CAUTION
Attention
Note
Warning Symbols
General hazard

Safety Precautions

CAUTION: Read all safety warnings before installing, making connections, or servicing this equipment.
Failure to comply with these warnings could result in personal injury and/or property damage. Retain all
instructions for future reference.

Verify that the local AC power supply voltage is within the input voltage range printed on the AC adapter's ratings label.

Only connect the AC adapter to a compatible grounded socket.

Position the instrument such that the AC adapter can be easily disconnected from the socket.

Position the power cord so that it does not pose a potential obstacle or tripping hazard.

Operate the equipment only under ambient conditions specified in the user instructions.

Do not operate the equipment in hazardous or explosive environments.

Disconnect the equipment from mains power before cleaning or servicing.

Service should only be performed by authorized personnel.
Intended Use
Use the instrument exclusively for <weighing/moisture determination/etc.> as described in the operating instructions. Any
other type of use and operation beyond the limits of technical specifications without written consent from OHAUS, is
considered as not intended.
This instrument complies with current industry standards and the recognized safety regulations; however, it can constitute a
hazard in use.
If the instrument is not used according to these operating instructions, the intended protection of the instrument may be
compromised and OHAUS assumes no liability.
2. INSTALLATION

2.1 External Connections

2.1.1 Scale Base to Indicator
Connect the load cell cable to the indicator as shown below:
Note: To connect T24PE to other bases, an optional loadcell connector (PN:30101021) needs to be purchased and soldered
as shown above.
For a hazardous situation with medium risk, possibly resulting in injuries or death if not avoided.
For a hazardous situation with low risk, resulting in damage to the device or the property or in loss
of data, or injuries if not avoided.
For important information about the product.
For useful information about the product.
Pin Connection
1 +EXE
2 +SEN
3 +SIG
4 GND
5 -SIG
6 -SEN
7 -EXE
Electrical shock
EN-1