Olympus PT-037 Manual De Instrucciones página 82

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 170
Q8:
What are the causes for entry of water?
A8:
The main causes for the entry of water are shown below. Please
check with special care.
1 The O-ring has not been installed.
2 The O-ring is partly or completely outside the groove.
3 Damage, deterioration or deformation of the O-ring
4 Sand, fibers, hair or other foreign matter on the O-ring
5 Sand, fibers, hair or other foreign matter sticking to the O-ring
EN
6 Catching of the strap, the bag of silica gel, etc. when sealing the
7 Throwing the Case from a boat into the water, jumping with the
Q9:
What are the important points for O-ring maintenance?
A9:
Pay special attention to the following items.
1 Never use alcohol, thinner, benzene or similar organic solvents
2 Use the genuine Olympus silicone O-ring grease (white cap).
3 In order to avoid deformation of the O-ring when the Case is not
4 The O-ring is a consumable part. Replace it at least once a year.
EN 40
grooves or the O-ring contact surfaces
Case
Case into the water, or other sudden application of strong forces
onto the Case. When entering the water, hand the Case over
gently or avoid impacts in other ways.
or chemical detergents to clean the O-ring. When such
chemicals are used, the O-ring may be damaged or its
deterioration will be accelerated.
The grease (red cap) used for previous Cases up till PT-008 and
the grease from other companies are not suitable for this silicone
O-ring. The use of such grease may cause deterioration of the
surface and impairment of the waterproof function.
used for a long time, remove the O-ring from the Case, apply a
thin coat of the special grease, and store the O-ring in a clean
plastic bag. For reuse, confirm that the O-ring is free of damage
and cracks, that it has sufficient elasticity, that the surface is free
of stickiness and other abnormalities, and use it after applying a
thin coat of the special grease. Excessive application of grease
does not improve the waterproof function or the permissible
withstand pressure. It will cause sand and dust to adhere more
easily. A thin, uniform coat produces the best result.

Publicidad

Tabla de contenido
loading

Tabla de contenido