Setting The Underwater Shooting Scene Mode; For Prevention Of Water Leakage Accidents - Olympus PT-037 Manual De Instrucciones

Setting the underwater shooting scene mode

The SP-550UZ camera incorporate several shooting scene modes for
underwater shooting, including wide-angle and macro modes. Simply
select the mode that's most appropriate for the scene you are shooting.
For details, see "5. Underwater Shooting According to the Scene
Type" (P.28) of this manual.
For details on mode setting, refer to the digital camera's operation
manual.

For Prevention of Water Leakage Accidents

When water leakage occurs while this product is being used, repair of the
camera housed in this product may become impossible. Please observe
the following cautions for use.
1 When sealing this product, make sure that no hairs, fibers, sand
particles or other foreign matter stick not only to the O-ring, but also to
the contact surface. Even a single hair or a single grain of sand may
cause water leakage. Please check with special care.
Examples of foreign matter sticking to the O-ring
Hair
2 The O-ring is a consumable part. Please replace it at least once a year
with a new one. Before each use, perform the proper maintenance.
3 Deterioration of the O-ring will acelerate according to the use conditions
and the storage conditions. Immediately replace the O-ring with a new
one if it is damaged, cracked, or has lost its elasticity.
4 During O-ring maintenance, clean the inside of the O-ring groove and
confirm the absence of dirt, dust, sand, and other foreign matter.
5 Apply the specified silicone O-ring grease to the O-ring.
Fibers Grains of sand
EN
EN 5