Mount/Remove The Lcd Hood; Mounting And Removing The Lens Cap; Perform The Final Checks; Visual Inspection - Olympus PT-037 Manual De Instrucciones

Mount/remove the LCD hood

Mounting: Fit the projected sections of the LCD hood into the guides
above and below the LCD monitor window.
Removing: Separate the projected sections of the LCD hood from the
guides above and below the LCD monitor window by
expanding the LCD hood outwards.
Guides

Mounting and removing the lens cap.

Fit the lens cap onto the lens ring as
shown in the figure. Be sure to
remove the lens cap before
shooting.

Perform the final checks.

Visual Inspection

After sealing the Case, check the sealing part of front and rear lid visually
to confirm that the O-ring is not twisted or out of the groove and that no
foreign matter has been caught. Also check that the Case is not broken or
cracked.
CAUTION:
Hairs, fibers, and other narrow items are not very apparent, but they may
cause entry of water. In addition, pay special attention to breaks and cracks
on the Case.
Mounting
Removing
EN 25
EN