PocketPower TSI102
2
Safety instructions
2.1
General safety
Only connect the device using the connecting cable to the 12 V cigarette lighter or
the 12 V onboard socket of the vehicle.
Do not connect the 230 V output of the inverter to a different 230 V source.
Always disconnect the power supply when working on the inverter.
Note that even after the fuse triggers, parts of the inverter remain live!
Never pull the plug out of the 12 V socket by the cable.
If the cable is damaged, it must be replaced to prevent possible electrical hazards.
Do not operate the device if it is visibly damaged.
People whose physical sensory or mental capacities prevent them from using this
device safely should not operate it without the supervision of a responsible adult.
This device may only be repaired by qualified personnel. Inadequate repairs can
cause considerable hazards.
If your device needs to be repaired, contact the manufacturer's customer service.
Disconnect the connection cable:
–
Before cleaning and maintenance
–
After use
Ensure that the ventilation slots are not covered.
Keep the inverter out of the reach of children.
2.2
Operating the device safely
Electronic devices are not toys!
Always keep and use the device well out of the reach of children.
When using the device in a vehicle, make sure that it does not impair operation of the
vehicle.
Before starting the device, ensure that the power supply line and the plug are dry.
Never start the device when your hands are wet.
Only operate the device when you or another person can attend to it.
Do not operate the device on hot surfaces.
Do not operate the device near flames or other heat sources (heating, direct sunlight,
gas ovens etc.).
Never immerse the device in water.
Protect the device and the cable against heat and moisture.
Only connect one consumer unit.
The manufacturer cannot be held liable for damage resulting from improper usage
or incorrect operation.
Safety instructions
13