Connecting The Inverter - Waeco PocketPower TSI102 Instrucciones De Uso

PocketPower TSI102
6

Connecting the inverter

Caution!
a
Make sure the plug (fig. 1 4, page 3) is firmly connected in the socket. If the
connection is loose, the plug may heat up and cause the inverter to malfunction.
Caution!
a
Do not operate any connected power consuming device while driving the vehi-
cle. Only operate device when vehicle is stationary.
Note
I
If you connect the device to the cigarette lighter, remember that the ignition must
be turned on to supply it with power.
➤
Fasten the inverter as follows (fig. 2 3, page 3):
– Screw the rail to the floor.
– Push the inverter onto the rail.
➤
Insert the plug into a 12 V cigarette lighter socket or into a 12 V on-board socket.
The middle pin (fig. 1 3, page 3) of the plug must be connected to the positive (+)
wire and the two side brackets (fig. 1 2, page 3) of the plug must be connected to
the negative (-) wire.
Connecting the 230 V device
➤
Insert the plug of the 230 V device into the 230 V output (fig. 1 4, page 3).
Charging the USB device
Note:
I
Always refer to the operating manual for your USB device.
➤
To charge a rechargeable device via the USB connection, plug the USB connection
of the device into the USB charger port (fig. 1 5, page 3).
Connecting the inverter
15