Delta MultiChoice 14 T20 Serie El Manual Del Propietario página 8

3 Backplate and Trim Installation
A.
1
Slide O-ring (1) over cartridge, wire and
the bonnet nut (2). The O-ring, which acts
as a spacer to steady the sleeve, should
rest behind the bonnet nut.
C.
F
C
2
Connect wire from cartridge (1) to back
side of backplate (2). Note: Switch (3) is
used to change the temperature from
Celsius to Fahrenheit.
2
3
1
14 T20 Series Installation
B.
2
1
If your model requires a spacer (1), insert
it into the sleeve (2) and push it to the
front. Slide the sleeve over the cartridge,
body and O-ring. Caution: Do not
damage the wire during installation
of the sleeve.
D.
1
Mount the backplate onto body using
screws (1) provided. Do not over
tighten screws.
7
1