14 T20 Series Installation
Backplate and Trim Installation
3
E.
Remove battery cover (1) by pushing in the
direction of the arrow. Insert 3 "AAA"
batteries (2) making sure to orient in
proper direction.
G.
1
Secure the escutcheon (1) by aligning the
4 tabs (2) with the 4 slots (3) in the back-
plate. Engage all 4 tabs fully into the slots
and rotate clockwise to lock.
1
2
2
F.
If shower wall is uneven, please seal back-
plate to the wall with silicone to prevent
moisture access to the electronics.
H.
3
Using an Allen wrench to secure the set
screw, install the handle onto the stem.
Note: If no set screw hole - handle may
have cap with screw.
8