Publicidad
compartment and the area behind the tail light assembly.
6. Locate a clean accessible mounting location on the vehicle
near the wiring harness ends within reach of the white wire and
grounding eyelet and drill a 7/64" hole.
Caution: Take care not to drill through the body or any
exposed surface.
7. Mount the White wire using the ground screw and eyelet
provided.
8. Route the 4-flat plug on the T-Connector harness into the
vehicle through the hole for the tail light wiring harness and
into the jack storage compartment. Push the T-Connectors black
box and additional wiring in through the tail light wiring hole.
Reposition the tape removed in step 5 over the wires to seal the
jack compartment.
9. Position the left (drivers) side rubber grommet over the
T-Connector harness and carefully position all the wiring inside the
vehicle behind the grommet. Seat the grommet into its mounting
hole.
10. Confirm correct operation with a test light or by using a trailer.
Note: All connections must be complete for the
T-Connector harness to operate.
11. Return the tail light assembly to its original position and
secure with the fasteners removed in step 2. Secure the black box
with cable ties (provided). Replace the jack storage cover and any
trim panels removed during installation. The 4-flat connector can
be stored in the jack storage compartment when not in use.
Publicidad
