Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Remove the left (drivers) side tail light assembly. There will
be a black connector on the vehicle wiring harness similar to that
found on the T-Connector harness.
Slide the red connector lock aside and
disconnect the vehicle harness from the
tail light assembly taking care not to
damage the locking tab (Fig. 1).
3. Carefully pull the vehicle wiring
harness and the rubber grommet out a
short distance from the vehicle. Plug the
matching
T-Connector harness end with the yellow wire between the tail light
assembly and the vehicle connector removed in step 2. Secure the
connectors together with the red locking tabs.
4. Using a utility knife, carefully slit the grommet as indicated
(fig. 2) from the hole for the tail light wiring harness to the outside
edge of the grommet. Carefully cut away the tabs that
connect the grommet to the wires.
Caution: Take care not to damage the
vehicle wiring harness while cutting the
grommet.
5. Remove the vehicle jack storage cover located
inside the rear of the vehicle on the left (drivers)
side and pull back the left trim panel to expose the
area behind. It may be necessary to remove the tape
covering the access hole between the jack storage
Fig. 1
Cut Line
Fig. 2
Publicidad
