Virutex EB140PLC Premilling Manual De Instrucciones página 44

E
D
(Figure 6.14)
H
(Figure 6.15)
J
(Figure 6.16)
P
Q
L
(Figure 6.17)
44 - EB140PLC Premilling / Annex operating instructions
C
F
I
H
P
Q
L
• Remove the tightening screws C (Fig. 6.14), remove the
tightening rod E, the feed roller rod D and the feed roller F
(Fig. 6.14).
• Remove the screws and washers H (Fig. 6.16), using key I
e/c: 13.
• Remove the motor J (Fig. 6.16). When removing the mo-
tor, be careful not to pull on the cable, as this may damage
the internal connections. The drive shaft, drive roller and the
bearing K (Fig. 6.16) will also come out with the motor J.
• Remove the 10 screws and washers L (Fig. 6.17 and Fig.
6.18), extract the feeder wheel assembly and replace the used
belt N (Fig. 6.18) with a new one.
• Remount the feeder wheel assembly M (Fig. 6.18), along
with the belt.
• Mount the rails Q with help of the centring pins P (Fig.
6.17).
• Mount the motor, keeping in mind the positioner O (Fig.
6.16) and fitting the bearing K (Fig. 6.16) in its housing.
K
O
J
L
N
(Figure 6.18)
L
M