Technical Data - LaserLiner SuperCross-Laser 2P Manual Del Usuario

The transport restraint must be released for horizontal and vertical levelling. The laser lines flash and the LED
!
lights red as soon as the device is outside the automatic levelling range of 4°. Position the device such that it
is within the levelling range. The LED switches back to green and the laser lines stop flashing (steady light).
3
Slope mode
Do not release the transport restraint, set the ON/OFF switch to „OFF". Select and switch on
the laser with the selection button. Sloping planes can now be measured. This mode cannot
be used to perform horizontal or vertical levelling as the laser lines are no longer aligned auto-
matically. The LED lights constantly red.

Technical Data

Automatic levelling range
Accuracy
Operating range (depending on room illumination)
Working range with hand-held receiver
Laser wavelength
Laser class / line laser output power
Power supply
Operating time
Temperature range, operating / storage
Dimensions (W x H x D)
Weight (without wall bracket and batteries)
Subject to technical changes without notice. 08.17
Guarantee, product care and disposal
This device complies with all necessary standards for the free movement of goods within the EU.
This product is an electric device and must be collected separately for disposal according to the
European Directive on waste electrical and electronic equipment.
Further safety and supplementary notices at: www.laserliner.com/info
08
EN
± 4°
±5 mm/10 m
20 m
depending on receiver: 30 to 50 m
635 nm
2/≤ 1 mW
4x 1.5V batteries (type AA, LR6)
approx. 25 hours
0 °C ... +50 °C/-10 °C ... +70 °C
66 x 119 x 124 mm
0.43 kg