Philips NORELCO QUADRA 7800XLCC/40 Manual De Instrucciones página 10

ENGLISH
18
Preparing Jet Clean System For Use
Important
◗ Only use the razor,power plug,Jet Clean System
and HQ200 cleaning solution provided to charge
or clean razor.
◗ Only use a Philips Norelco 'XLCC' model
razor with the Jet Clean System.
◗ Other Philips Norelco'X','XL' or'LC' model
razors DO NOT work with a Jet Clean System.
◗ Empty the cleaning solution canister and
thoroughly rinse the canister clean with warm
water every 2 weeks.
◗ The Jet Clean System thoroughly cleans but
does not disinfect your razor, therefore, do not
share razor with others.
◗ The charging plug converts 100-240VAC to
less than 24V DC.
◗ Place the Jet Clean System on a flat, stable
surface to avoid any leakage. Be careful not to tip
or move the Jet Clean System if it is filled with
the cleaning solution.
◗ To avoid evaporation, do not expose cleaning
solution to direct sunlight.
◗ Remove the protective razor head cap from
the razor before charging or cleaning the razor
in the Jet Clean System.
◗ Use this appliance for its intended household
use as described in this manual.
Place the Jet Clean System on a flat,level
1
surface.
C
Lift the transparent cleaning reservoir
2
from the Jet Clean System.
C
Turn the reservoir cap counterclockwise
3
(1) and remove from the cleaning
reservoir (2).
Unscrew the lid on the Jet Clean Solution
4
bottle (Model HQ200) provided with the
razor. Remove the airtight seal by lifting up
the tabs on the seal. Replace lid on the bottle
making sure the lid is screwed on securely.
Open lid and pour the Jet Clean Solution into
5
the transparent cleaning reservoir. The
reservoir can be completely filled with one
(1) bottle of the Jet Clean Solution (Model
HQ200).Discard cleaning solution bottle
after contents have been poured into the
reservoir.
NOTE: ONLY USE PHILIPS NORELCO JET
CLEAN SOLUTION (MODEL HQ200)WITH
THE JET CLEAN SYSTEM. ANY OTHER
SOLUTION MAY CAUSE DAMAGE TO YOUR
RAZOR.
ENGLISH
19