Philips NORELCO QUADRA 7800XLCC/40 Manual De Instrucciones página 13

ENGLISH
24
C
Press the Razor Head Release Button, flip
2
open the Razor Head Assembly.
C
Clean inside razor heads and hair chamber
3
by running under hot water.
C
Clean outside of Razor Head Assembly by
4
running under hot water.
Close the Razor Head Assembly and shake
5
off excess water.
C
Open Razor Head assembly again and
6
leave open to air dry.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue.This could damage the
shaving heads.
C
If the shaving unit becomes detached from
7
the razor, you can easily reattach it.
You may also clean the hair chamber
8
without water by using the supplied brush.
After Each Use: Trimmer
Turn razor OFF.
1
Push down spring-release trimmer switch.
2
C
Clean trimmer with the brush every time
3
you use it.
C
Lubricate the trimmer teeth with Philips
4
Norelco Razor Lubricant (model AL80) or
with one drop of mineral oil every 6 months.
Close trimmer by pressing trimmer down.
5
This razor and Jet Clean System have no other user-
serviceable parts. Any other service should be
performed by the Philips Norelco Service Location.
Cleaning the Jet Clean Canister
For optimal performance of the Jet Clean System,it
is recommended that you empty the cleaning
solution canister and thoroughly rinse the canister
clean every 2 weeks.
Place the Jet Clean System on a flat, level
1
surface.
C
Simultaneously press the buttons located on
2
both sides of the Jet Clean System (1) and
lift the appliance off the Jet Clean canister (2).
Always remove appliance from canister by lifting
straight up. Do not tilt Jet Clean System.
ENGLISH
25