Nice ETPB Instrucciones Y Advertencias De Instalación Y Uso página 7

–– Programming "MASTER" cards ––
Programming the "MASTER" cards is the first operation to be carried out and should be
done when the reader's memory is still empty. In practice "MASTER" cards are the first
card which must be placed up to the reader for at least 5 seconds. CAUTION! – To
program "MASTER" cards, use only one of the available procedures (7.1 or 7.2).
7.1 Professional
Program MASTER-1 (memorises cards that enable com-
mand no. 1) and MASTER-2 (memorises cards that enable
command 2)
CAUTION! – This procedure is an alternative the one described in paragraph 7.2.
May only be carried out if the reader memory is empty.
01. Make sure the reader's memory is empty.
02. Hold a new card (this will be "MASTER-1") in front of the reader for at least 5
seconds. After 5 seconds have elapsed, the reader emits 3 consecutive acoustic
signals and 1 single signal.
03. After the signals, remove the card from the reader.
04. Place another new card (this will be "MASTER-2") in front of the reader and
hold it there for at least 5 seconds. After 5 seconds have elapsed, the reader
emits 3 consecutive acoustic signals and 1 single signal.
05. After the signals, remove the card from the reader.
7.2 Professional
Program the SINGLE MASTER card (memorises cards
which enable commands no. 1 and no. 2 individually or both
together)
CAUTION! – This procedure is an alternative the one described in paragraph 7.1.
May only be carried out if the reader memory is empty.
01. Make sure the reader's memory is empty.
02. Hold a new card in front of the reader for at least 5 seconds. After 5 seconds
have elapsed, the reader emits 3 consecutive acoustic signals and 1 single signal.
03. After the signals, remove the card from the reader.
04. Hold the same card in front of the reader and keep it there for at least 5 seconds.
After 5 seconds have elapsed, the reader emits 3 consecutive acoustic signals
and 1 single signal.
05. After the signals, remove the card from the reader.
–– Programming normal cards ––
7.3 Professional
Program (with MASTER-1) the cards that enable com-
mand no. 1
01. Pass MASTER-1 in front of the reader once.
02. Pass the new card in front of the reader once. Note – After the first card, other
cards can be programmed by repeating point 02 for each one within 10 seconds
of passing the last card.
03. To terminate the procedure, pass MASTER-1 once in front of the reader or wait
more than 10 seconds after passing the last card.
Additional cards can be memorised at any time by repeating this procedure from the
beginning.
7.4
Professional
Program (with MASTER-2) the cards that enable com-
mand no. 2
01. Pass MASTER-2 in front of the reader once.
02. Pass the new card in front of the reader once. Note – After the first card, other
cards can be programmed by repeating point 02 for each one within 10 seconds
English – 5