Technical Data; Noise Information; Vibration Information - Worx WG160E Manual Del Usuario

TECHNiCaL DaTa

Type wG160E (1-designation of machinery, representative of Grass Trimmer)
Voltage
No load speed
Cutting diameter
Line diameter
Charging time
Machine weight
*Voltage measured without workload. Initial battery voltage reaches Maximum of 20volts.
Nominal voltage is 18volts.

NoisE iNformaTioN

A weighted sound pressure according to Annex E of EN 786
K
pA
A weighted sound power according to Noise Directive 2000/14/EC
Wear ear protection

VibraTioN iNformaTioN

Vibration emission value according to Noise Directive 2000/14/EC
Uncertainty K
wARNING! The vibration emission value during actual use of the power tool can differ
from the declared value depending on the ways in which the tool is used dependant on the
following examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
wARNING! To be accurate, an estimation of exposure level in the actual conditions of use
should also take account of all parts of the operating cycle such as the times when the tool
is switched off and when it is running idle but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
Helping to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
3-in-1 Grass Trimmer/Edger
20V Max*
7600/min
30cm
1.65mm
3hr
2.6kg
L = 78dB(A)
pA
3.0dB(A)
L = 94dB(A)
wA
7
a = 2.8m/s²
h
1.5m/s²
EN