Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Some dust created by
power sanding, sawing, grinding, drilling
and other construction activities contains
chemicals known to the state of California
to cause cancer, birth defects or other
reproductive harm. Some examples of these
chemicals are:
•
Lead from lead-based paints;
•
Crystalline silica from bricks and cement
and other masonry products;
•
Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemical: work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed
to filter out microscopic particles.
WARNING: This product can expose you
to chemicals including lead, phthalate
or bisphenol A which are known to the State of
California to cause cancer, birth defects or other
reproductive harm. Wash your hands after use.
For more information go to www.P65Warnings.
ca.gov.
COMPONENT LIST
1.
TELESCOPIC POLE HANDLE
2.
ON/OFF SWITCH
3.
LOCKING KNOB
4.
INNER HANDLE
5.
CONNECTION PIN
6.
CONNECTION BRACKET
7.
LOCK-OFF BUTTON
TECHNICAL DATA
Length (height to ground) *
Max Telescopic Length
Lower Level
Cutting Height
Higher Level
Weight
* Length (height to ground) means the vertical
distance from the telescopic pole handle to the
ground.
Telescopic Handle
NOTE: Before using the telescopic handle, read
the instruction book carefully as well as the
instruction book of Grass Shear.
WARNING: Before attaching the
telescopic handle, make sure that the
battery pack has been removed.
ASSEMBLY AND OPERATION
1. Assembling/removing the telescopic handle
(See Fig. A1)
Assembling: Align and insert the handle connection
bracket into the machine.
Removing: Disconnect the handle connection bracket
by pressing and holding down on the locking tab
(See Fig. A2) and then pulling the shear off the
handle.
NOTE: After assembly, make sure the connection
pin on the bottom of the connection bracket is flat, if
it is protruding, please re-assemble the handle. (See
Fig. A2)
NOTE: Make sure the telescopic handle is locked into
position securely before operation.
2. Adjusting the handle length (See Fig. B)
Loosen the locking knob to extend the handle, and
the handle will slide freely.
Then tighten the locking knob to lock the handle in
position.
NOTE: The locking knob is used to hold the handle in
position at any extended length.
3. Adjusting the cutting height (See Fig. C1, C2)
Press the left wheel to push the spring inside. Hold
the spring in position and then rotate the wheels to
adjust the cutting height. Release the spring and then
the wheels will be fixed in position.
NOTE: The telescopic handle has two cutting height
levels (1''&1.7'').
4. On/Off switch (See Fig. D)
Push the Lock-off button forward to the unlock position
and then fully press the On/Off switch. Then release
the Lock-off button. This will turn the machine on.
Release the On/Off switch will turn the machine off.
27''-44''
16''
1''
1.7''
1.0 lbs
5
EN
Publicidad
Tabla de contenido
