Installation Steps - LUND RAMPAGE TrailGuard Instrucciones De Instalación

Installation Steps

Insert Frame Support Bracket into Passenger / Right side of frame.
1
Using the provided 12mm x 110 mm bolts and welded nut plates, bolt the bumper to the rear crossmember of the Jeep.
3
Adjust bumper so that it is even and level. Tighten all hardware.
4
NOTE: Actual application may vary slightly from illustrations.
Line up Bumper with holes in frame. Use provided 14mm hardware
to attach Bumper to frame on both sides. There are four (4) mount-
ing points on each side. Leave hardware hand tight at this time.
2
Install Plastic Plug into hole on passenger side of bumper. If install-
ing a Swing Away, proceed to the instructions provided with the
5
Page 2 of 3
Swing Away components.