Tool Use - Senco SFW05-AT Instrucciones De Empleo

GB
4
When using tool, care should be taken due to possibility of tool recoil.
If safety yoke is unintentionally allowed to re-contact work surface
following a recoil, an unwanted fastener will be driven. Therefore, allow
tool to recoil completely off work surface to avoid this condition. Do not
push safety yoke on work surface until a second fastener is desired.
Disconnect tool from air before doing tool maintenance, clearing a
jammed fastener, leaving work area, moving tool to another location,
or handing the tool to another person.
Tool may eject a fastener when onnected to air supply; therefore,
remove all fasteners from tool before connecting air.
Never use tool if trigger or springs have become inoperable, missing
or damaged. Do not tamper with or remove trigger, or springs.
Make sure all screws and caps are securely tightened at all times.
Never use the tool if parts are missing or damaged.
Use only parts, fasteners, and accessories recommended or sold by
SENCO. Do not modify tool without authorization from SENCO.
Use only clean, dry, regulated compressed air at recommended
pressure (see page 7).
Tool shall not be connected to pressure which potentially exceeds
maximum operating pressure by 10%.
Tool marked with an inverted triangle may not be used unless fitted
with an effective safety yoke.
Stands for mounting tools to a support shall be designed and
constructed by the standmanufacturer in such a way that the tool can
be safely affixed for the intended use.
The tool and air supply hose must have a connecting nipple such
that all pressure is removed from the tool when the coupling joint is
disconnected.
Do not load fasteners with trigger depressed.
Do not use tool without warning label on tool. If label is missing,
damaged or un readable, contac t your SENCO representative to
obtain a new label.
Never use a tool that leaks air or needs repair.
Always place yourself in a firmly balanced position when using or
handling the tool.

TOOL USE

Read section titled "Safety Warnings" before using tool.
Keep tool pointed away from yourself and others and connect air
to tool. Tools shall be operated at lowest pressure needed for the
application. This will reduce noise levels, part wear and energy use.
To load: Push latch and slide rail open.
Lay strip of fasteners into magazine. Use only genuine SENCO
fasteners (see Technical Specifications). Do not load with trigger
depressed.
Push rail forward until it latches .
Never use a tool that leaks air or needs repair.
GB
5