Tabla De Contenido; Important; Safety Warnings - Senco SFW05-AT Instrucciones De Empleo

English
GB
Deutsch
D
Nederlands
NL
Français
F
Suomi
FIN
Norwegian
N
Svenska
S
Dansk
DK
E Español
Italian
I
Polski
PL
Pyccкий
RUS
Türkçe
TR
2
3
9
15
21
27
33
39
45
51
57
63
69
75

ImPORTaNT

It is the employer's responsibility to assure this manual
is read and understood by all personnel assigned to use
the tool. Keep this manual available for future reference.

SaFETy WaRNINGS

Read these warnings to prevent injuries to yourself and bystanders.
Refer to tool use, maintenance and troubleshooting sections for
additional information.
To prevent eye injuries, always wear OSHA required "Z87" safety
glasses with permanently attached rigid, hard plastic side shields.
These safety glasses must have "Z87" printed or stamped on them.
Be sure everyone in your work area is wearing the same type of safety
glasses.
Always wear other personal protective equipment such as hearing
protection and hard hat.
Never use oxygen, carton dioxide or any other bottled gas as a power
source for this tool; the tool will explode and cause serious injury.
Remove finger from trigger when not driving fasteners. Never carry
tool with finger on trigger.
Always assume the tool contains fasteners. Keep the tool pointed
away from yourself and others. No horseplay. Respect the tool as a
working implement.
Fire fasteners into work surface only; never into materials too hard to
penetrate.
Do not drive fasteners on top of other fasteners or with the tool at too
steep of an angle; the fasteners can ricochet and hurt someone.
Do not drive fasteners close to the edge of the work surface. The
workpiece is likely to split and the fastener could fly free or ricochet
and hit someone.
TaBLE OF CONTENTS
Safety Warnings 3
Tool Use 5
Maintenance 6
Troubleshooting 7
Accessories 7
GB
Technical Specifications 8
Declaration of Conformity 8
3