Horizon Global 24969 Instrucciones De Instalación página 4

1a. Lower Fascia removal - Using a Phillips head screw driver, remove (5)
screws located at bottom inside edge of lower fascia. Using a T30 Torx remove
(3) screws located at the bottom inside edge of the lower fascia.
2. Remove lower bumper attachment - Using a 13mm socket remove
the existing lower bumper attachment nut on the driver side only.
©2017 Horizon Global™ Corp - Printed in Mexico
1b. Using a plastic trim panel tool, gently remove the lower plastic fascia
starting at the outer edges.
3. Install mounting plates– Place plates (item 2) on top of bumper support
as shown and install 4" carriage bolts (item 1) TIP: It is easier if the plate is fed
in from the center with the outer bolt already in the plate.
Sheet 4 of 18 24969NP 11-10-17 Rev. A