Install The Solenoid - Kohler K-10958 Guía De Mantenimiento

Cap
DC Sensor
Connector
Retaining Nut
Solenoid
Connector
Pin
Diaphragm

Install the Solenoid

CAUTION: Risk of property damage. Do not overtighten the
solenoid as damage to the solenoid can occur.
CAUTION: Risk of property damage. Ensure that the
solenoid wires are not caught between the cap and the valve
body.
Align the solenoid to the hole in the piston cover.
Install the solenoid and tighten with an adjustable wrench by
turning clockwise.
Connect the DC sensor connector to the solenoid connector and
locate the connector assembly next to the sensor body to avoid
pinching.
Place the cap on the valve body and secure with the setscrew.
Open the control stop valve (refer to the "Control Stop Valve
Operation" section).
Verify that the valve functions.
Kohler Co.
Setscrew
Solenoid
Assembly
Spring
Valve Body
13
O-Ring
Piston
Cover
Piston
1061436-5-B