PEERLESS RTLA-100 Manual De Instalación Y Montaje página 6

• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
Note: To add security, order ACC 918 for security screws. Refer to ACC 918 instruction sheet for installing security screws.
FOR VESA ® 75 MOUNTING PATTERN:
2
Choose hole pattern as shown below. Attach
adapter plate (B) to back of screen using four M4 x
12 mm screws (I) as shown below.
*Note: If hole pattern is in a pocket, attach adapter
plate (B) to back of screen using four M4 x 20 mm
screws (J) and four retaining spacers (K) as
indicated below.
fig. 2.1
Note: If the ball joint feels loose
3
or too easy to adjust, slightly
tighten cap socket screw until
ball joint feels firmly in place.
Insert two M5 x 10 mm screws
(C) into top two holes of adapter
plate (B) leaving approximately
1/4" of exposed thread. With
slots facing upward, hook
screws onto wall arm ball joint
as shown in figure 3.1.
Insert one M5 screw (C)
through bottom hole of wall arm
ball joint into adapter plate (B)
as shown in figure 3.2.
WARNING
*For screens with a
hole pattern in a
pocket, spacers (J)
go between adapter
K
plate (B) and screen.
B
Screen may appear
slightly different than
I
illustrated
fig. 3.1
B
WALL ARM
BALL JOINT
FOR VESA 100 MOUNTING PATTERN:
Choose hole pattern as shown below. Attach adapter plate
(B) to back of screen using four M4 x 12 mm screws (J) as
shown below.
fig. 2.2
C
1/4"
CAP SOCKET
SCREW
6 of 24
C
ISSUED: 05-09-05 SHEET #: 095-9224-4 08-23-05
B
I
fig. 3.2
B