To get full range of motion and enough tension to hold the screen in any position, simply tighten or loosen cap socket
6
screw a few turns using 4 mm allen wrench (G).
• Do not remove screw or loosen screw until it is no longer engaged with the mount. Doing so may cause the screen to fall.
If more or less tension is desired in the arm pivot points, do the following:
7
• To increase tension, turn socket screw clockwise with 3/16" allen wrench (D).
• To reduce tension, turn socket screw counter-clockwise with allen wrench (D). Do not turn more than half a turn.
WARNING
Ball join design at screen for easy side-to-side
movement and ±35° of tilt.
8 of 24
All other brand and product names are trademarks or registered trademarks of their respective owners.
CAP SOCKET SCREW
SOCKET
SCREWS
ISSUED: 05-09-05 SHEET #: 095-9224-4 08-23-05
© 2005 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.