PEERLESS RTLA-100 Manual De Instalación Y Montaje página 7

4 Route cords through center of cord management clip (H). Next, attach cord management clip (H) to wall arm ball
joint using M5 screw (C) as shown in detail 1. Tighten all four screws (C).
Note: A cord management clip (H) was added for additional cords. If you want to use this additional clip (H), remove
the opposite bottom screw and repeat this step on opposite side of wall arm ball joint.
H
Note: Make sure cords have enough slack to allow full movement of the arm.
5
Route cords inside arm slots of wall arm assembly (A). Optional: Run power cord through one side of mount and
signal cable(s) through other side to avoid interference with the signal.
Lock cords into place by sliding cord covers onto mount as shown in detail 2. Screen may have to be moved for better
access for sliding on the cord covers.
WALL ARM
BALL JOINT
detail 1
A
C
CORD COVERS
detail 2
7 of 24 ISSUED: 05-09-05 SHEET #: 095-9224-4 08-23-05