How To Use - Seiko 5R66 Instrucciones

Hour hand
Second hand
Power reserve indicator
CROWN
a) Normal position
b) First click position
c) Second click position : time settings
6
Minute hand
CROWN
a b c
Moon phase display
: winding up the mainspring (manual operation)
: moon phase setting
[Caliber 5R67]

HOW TO USE

This watch is an automatic watch equipped with a manual winding mechanism.
• When the watch is worn on the wrist, the motion of the wearer's arm winds the
mainspring of the watch.
• If your watch is completely stopped, it is recommended that you manually wind the
mainspring by turning the crown.
● How to manually wind the mainspring by turning the crown (for Cal. 5R66 & 5R67)
1. Slowly turn the crown clockwise (the 12 o'clock direction) to wind the mainspring.
* With manual winding, if you give the crown five full
rotations, it provides the power to run the watch for
approximately ten hours.
* Turning the crown counterclockwise (the 6 o'clock
direction) does not wind the mainspring.
2. Wind the mainspring until the power reserve indicator shows a fully-wound state.
The second hand will start moving.
* To check the winding state of the mainspring, refer to
"HOW TO READ THE POWER RESERVE INDICATOR"
on page 22.
* There is no need to turn the crown further when the
mainspring is fully wound. But the crown can be turned
without damaging the watch mechanism.
7