Descargar Imprimir esta página

Safety 1st BALADIN Gr0/1 Manual De Instrucciones página 15

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
always put the child in the child car seat,
however short your journey may be.
• Ensure that the straps under the stomach lie
as low as possible, to properly support the
pelvis.
• The temperature inside a vehicle may become
very high, particularly after a long period of
exposure to the sun. It is strongly recommend-
ed, under such conditions, to cover the seat of
the car with a piece of material or something
equivalent to prevent the harness fi xings, and in
particular the metal parts, from becoming hot
and burning the child.
OTHER INSTRUCTIONS:
• This child restraint is effective only if the
instructions for use are respected.
• Always fasten the child restraint even when
the child is not sitting in it.
• The user must always check that any luggage
and other objects likely to cause injury to the
occupant of the car seat in the case of impact
are properly secured.
• Never place heavy objects on the rear parcel
shelf, to avoid the danger of projectiles in the
event of an accident.
• The rigid parts and the plastic sections of a
child restraint device should be positioned and
installed in such a way that they cannot, when
the vehicle is being used under normal
conditions, become trapped under a moving
seat or in the vehicle door.
• Always check that no part of the seat or the
harness is trapped under a seat or in the vehicle
door.
manual_014854601_safety1st_baladin_2015_EN-FR-DE-NL-ES-IT-PT.indd 15
• It is essential that the car seat be replaced
after an accident.
• Never modify the construction or the
materials of the car seat and the seat belt
without consulting the manufacturer.
• Do not use the child restraint device without
the cover. Do not replace the seat cover with a
cover other than that recommended by the
manufacturer, because it will have a direct
effect on the functioning of the child restraint.
• Folding seats must always be locked in place
• After purchasing, install the seat in your
vehicle. If you encounter any installation
problems due to the length of the vehicle seat
belt, contact your distributor immediately (prior
to use).
• If in any doubt about the correct installation
or use of the system, the user is advised to
contact the distributor or the manufacturer of
the child restraining device system.
15
EN
27/06/14 08:42

Publicidad

loading