pico Technology PicoScope 6000E Serie Guia De Inicio Rapido página 10

PicoScope 6000E Series oscilloscopes
Temperature
Humidity
(non-condensing)
Altitude
Pollution degree
2.6 Care of the product
The product contains no user-serviceable parts. Repair, servicing and adjustment require specialized test equipment
and must only be performed by Pico Technology or an approved service provider. There may be a charge for these
services unless covered by the Pico five-year warranty.
Inspect the instrument and all probes, connectors, cables and accessories before use for signs of damage.
To prevent electric shock do not tamper with or disassemble the oscilloscope, case parts, connectors or
accessories.
When cleaning the product, use a soft cloth and a solution of mild soap or detergent in water. To prevent electric
shock, do not allow liquids to enter the oscilloscope casing, as this will compromise the electronics or insulation
inside.
Do not block the air vents at the back or front of the instrument as overheating will damage the oscilloscope.
Do not insert any objects through the air vents as internal interference will cause damage to the oscilloscope.
2.7 Conformance
FCC notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference which the user will be required to correct at their own expense.
CE notice
This PicoScope 6000E Series oscilloscopes have been designed and tested in accordance with the following
European Union directives: 2014/30/EU (EMC), 2014/35/EU (LVD), 2012/19/EU (WEEE) and 2011/65/EC (RoHS), and
left the factory in a safe condition.
For more information, please refer to your product's EU declaration of conformity, available for free download from
picotech.com/downloads.
6
Storage
–20 to +60 °C
5 to 95 %RH
EN 61010 pollution degree 2: "only non-conductive pollution occurs except that
occasionally a temporary conductivity caused by condensation is expected"
WARNING
CAUTION
Copyright © 2020 Pico Technology Ltd. All rights reserved.
Operating
0 to 40 °C
5% to 80% RH
Up to 2000 m
Quick Start Guide
Quoted accuracy
15 to 30 °C after 20
minutes' warm-up
DO338-2