Carburetor Adjustment; Cutting Means Removal; Select Drive Cable Adjustment - Honda HRX476C Manual De Proprietário

CARBURETOR ADJUSTMENT

CAUTION:
• It is recommended to ask your servicing dealer for adjustment.
Specified idle speed: 1 700 ± 150 min
+
Operating speed: 2 800 - 100
SHIFT CABLE ADJUSTMENT
HYEH, QYEH types:
Measure the free play [1] on the side of lever [2] as shown.
1. Place the gear stick in the fastest position and loosen the locknuts [3].
2. Relax or tighten the cable as necessary so that a free play of 1
to 5 mm is achieved.
3. Retighten the locknuts [3] and recheck the free play [1].
4. Start the engine in the open air and operate the clutch lever.
Check that the clutch engages and disengages correctly.
[1]
HYEH
QYEH

SELECT DRIVE CABLE ADJUSTMENT

VKEH, VYEH types:
Perform this procedure with the wheels on a level surface.
1. Move the Select Drive control knob [4] in "-" position [5].
2. Loosen the Select Drive clutch cable lock nut [6].
3. Start the engine.
4. Without engaging the Select Drive control, turn the Select Drive
clutch cable adjuster [7] in the "START" [A] direction until the
lawnmower just begins to move forward.
5. Turn the Select Drive clutch cable adjuster 1 ~ 2 turns in the
"STOP" [B] direction.
6. Tighten the Select Drive clutch cable lock nut.
[5]
[4]
[B]
[7]
[6]
14 EN
SAFETY
-1
0
-1
min
SAFETY
[2]
[1]
[2]
SAFETY
[A]
All models:
C1 C13
NOTE: If the clutch does not engage correctly even when the cable
is correctly adjusted, the system may need to be repaired. Take the
lawnmower to an authorized dealer.
CUTTING MEANS FITTING AND
REMOVAL

CUTTING MEANS REMOVAL

1. Place the throttle lever in "STOP" position (Rotostop drive
C17
models).
2. Turn the fuel valve to the OFF (close) position and disconnect
the spark plug cap from the spark plug.
3. Tilt the lawnmower so that the carburetor faces upwards [8].
[3]
4. Use a 14 mm socket wrench and remove the 2 cutting-means
[3]
bolts [9] and special washers [10] from the cutting-means holder
[11].
Use a wooden block to prevent the cutting means from turning
when removing the bolts.
[3]
HYEH, VKEH, VYEH types:
5. Remove the upper [12] and lower cutting means [13].
[3]
C17
QYEH type:
5. Remove the cutting means [14] and spacer [15].
SAFETY
[8]
[12]
[13]
[11] [10] [9]
[15] [14]
[11]
[10]
[9]
B3 C19
D7 D8 D9