Connect The Ethernet Cable - Cognex ISC-7800 Serie Manual

Connect the Ethernet Cable

The camera's ENET connector provides an Ethernet connection.
CAUTION:
Cognex recommends only cold-plugging the camera; turn the vision
l
controller power off when connecting or disconnecting the camera.
The Ethernet cable shield must be grounded at the far end.
l
1. Connect the Ethernet cable's M12 connector to the camera's ENET
connector.
2. Connect the other end of the cable to one of the vision controller's CAM
ports.
Note: If using a vision controller that supports a two camera
configuration, connect the camera Ethernet cables to the vision
controller's CAM 0 and CAM 1 ports.
3. Restore power to the camera's 24VDC power supply and turn it on if
necessary.
4. Restore power to the vision controller's 24VDC power supply and turn it on
if necessary.
12