Installing And Removing The Battery Pack - DeWalt DW937 Manual De Instrucciones

To unlock the trigger switch, press the lock-off button as shown in
Figure 2. Pull the trigger switch to turn the motor ON. Releasing the
trigger switch turns the motor OFF.
NOTE: This tool has no provision to lock the switch in the ON position,
and should never be locked ON by any other means.
The variable speed trigger switch will give you added versatility. The
further the trigger is depressed the higher the speed of the saw.
CAUTION: Use of very slow speed is recommended only for
beginning a cut. Prolonged use at very slow speed may damage
your saw.
Installing and Removing the
Battery Pack
NOTE: Make sure your battery pack is fully charged.
CAUTION: Lock trigger switch before removing or installing battery.
To install the battery pack into the tool handle, align the base of
the tool with the notch inside the tool's handle and slide the battery
pack firmly into the handle until you hear the lock snap into place as
shown in Figure 3.
To remove the battery pack from the tool, press the release buttons
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger manual.
FIG. 3
FIG. 4
Blade Installation and Removal
Different blade lengths are available. Use the appropriate blade for
the application. The blade should be longer than 3 1/2" and should
extend past the shoe and the thickness of the workpiece during the
cut. Do not use jigsaw blades with this tool.
WARNING: Blade breakage may occur if the blade does not
extend past the shoe and the workpiece during the cut (Fig. 4).
Increased risk of personal injury, as well as damage to the shoe and
workpiece may result.
CAUTION: LOCK TRIGGER SWITCH AND REMOVE BATTERY
PACK.
TO INSTALL BLADE INTO SAW
1. Open blade clamp release lever
(C) up (Fig. 5).
2. Insert blade shank from the front.
3. Close blade clamp release lever
down.
4. Note blade can be installed
upside-down to assist in flush-to
cutting, see Figure 7.
8
FIG. 5
C