Alarms; Master Unit - La Sommeliere ECELLAR185 Manual De Instrucciones

Alarms

To guarantee total safety of your wines; your cellar is equipped with an alarm system;
- High temperature alarm
- Low temperature alarm
These alarms are pre-programmed. If after 12 hours of operation, the cellar detects a temperature
difference of ± 4 ° C from the setpoint temperature, then the cellar will display an error code
corresponding to the high or low alarm and an audible alarm will sound. In the event of a fault, the
compressor will operate in short cycles of 10 minutes ON and 10 minutes OFF.
To deactivate the audible alarm, press one of the buttons on the control panel. If any of these
alarms are activated, please contact the after-sales service.

Master unit

Your cellar is equipped with a master unit. This unit control is placed inside the cellar, top right; it
allows connectivity between the shelves and the VINOTAG® smartphone application via wifi data
transmission.
Warning ! Under no circumstances should this unit control be handled, or damaged.
This unit control is equipped with an indicator light placed under the box which gives information on
the condition of the cellar and a push button which is used to reset the wifi connection from the cellar
to the network. When the indicator light flashes continuously, this indicates that the cellar is not
connected to wifi network or has lost its connection to a WiFi network. The box is also provided with a
QR code located under its lower edge.
•
First use
The QR code is used for pairing the cellar (in Bluetooth). You will need to scan this QR code during
the first use to connect your cellar to the wifi network.
Warning ! The QR code scan as well as the pairing procedure only have to be carried
out once! If you do this operation on a cellar already associated with a user, you
become the new owner and overwrite all the data previously associated with the
cellar. This will give you access to an empty cellar and the previous owner will no
55