Product Description; Function Keys; Operating Modes - WOOD'S LD48PRO+ Instrucciones De Uso

EN
OPERATION INSTRUCTIONS
"A.
1. Control panel
2.
Draught valve to open/close/aim the air
stream
3.
Air filter
4.
Water container
5.
Change of air filter"
B.
CONTROL PANEL -
FUNCTION DESCRIPTION
Dehumidifiers in the LD series are equipped
with an intuitive control panel for simple and
convenient use. Note that the control panel
powers down to idle mode 20 seconds after
connection of mains voltage or after last input
and is revived by touching the area where the
function keys are located. All keystrokes are
confirmed with a beep

FUNCTION KEYS

1.
On/OFF- Switches the dehumidifier on and
off. In off mode the energy consumption
equals 0.5 W.
2. Setting of the desired humidity - Only
active in program modes "Normal" and
"Fan". Desired humidity can set between
35 - 75% in steps of 1 percentage point.
The set value is first displayed fixed and
then flashing before the actual value
reappears.
3.
Mode selection - Selection of operating
program, refer points 13. - 16. below.
4.
Fan speed - The speed of the fan may in
"Normal" and "Fan" mode be set at low or
high speed. Switching between the speeds
takes place with a few seconds delay.
06

PRODUCT DESCRIPTION

ALARMS / INFORMATION
5. Defrost - If necessary, the cooling circuit
is defrosted automatically, whereby the
compressor is switched off and only the
fan is in operation. The symbol goes out
when the dehumidification process is
restarted.
6.
Too high ambient temperature – If the
ambient temperature exceeds 35 ° C the
dehumidification process shuts off and
resumes automatically when the ambient
temperature falls below 35 °C. The symbol
is lit as long as the temperature is 35 ° C
or higher.
7. Low room temperature – if the ambient
temperature falls below2 ° C the
dehumidification process shuts off and
resumes automatically when the ambient
temperature rises above 2 °C. The symbol
is lit as long as the temperature is 2 ° C or
lower.
8.
Condensate tank full – When the tank is
full an audible signal is activated for 20
seconds and the symbol is lit. When the
water tank is emptied and repositioned,
the reset is reset the operating program
automatically. Make sure that the float
hangs freely in the tank.
9. Room temperature – Displays the detected
ambient temperature.
10. Fan speed - Fan and dashes indicate high
speed and only fan indicates low speed.
11. Relative humidity - Shows current and
desired target values. The latter in
connection with target value setting.
12. WiFi - Indicates when WiFi is connected.
Applies only to models equipped with this
feature.

OPERATING MODES

13. Fan mode - Used if continuous air
circulation is desired. Fan speed and
target value for humidity can be set. When
the set target value is reached, only the
compressor is switched off to restart again
if the humidity rises.
14. Comfort mode (EASY) - The dehumidifier
aims for 50% relative humidity with the fan
set to low speed. When the target value is
reached, compressor and fan shuts off and
restarts if the humidity rises above 50%.
15. Laundry drying mode (LAUNDRY) - The
dehumidification process is in operation
with the fan at high fan speed until it
is turned off manually or the mode is
changed.
16. Normal Mode (NORMAL) – Used to
manually set the target value for humidity
and fan speed. When set target value is
reached, compressor and fan shuts off
and restarts if the humidity rise above the
target value.
17. Lock function - Used to prevent that
settings unintentionally are changed. The
lock function is operating the FAN and
MODE keys simultaneously for 3 seconds.
Disabling the lock function is done in the
same way. "