Rampage 86510 Instrucciones De Instalación página 2

Installation
NOTE: Actual application may vary slightly from illustrations.
2
Remove (2) plastic keepers near bottom of
plastic skid plate that attach to the frame
crossmember.
See Figure 2.
3
From underneath the front bumper, disconnect the factory fog lights, if equipped.
Separate the wiring harness from the bumper but pulling the clips off the bumper and cutting
any tie wraps.
4
Un-bolt the factory front bumper by
removing a total of (8) nuts that secure it
to the frame. There are 2 on both sides of
each frame rail.
Carefully remove bumper from the
vehicle.
See Figure 3.
5
Remove the two plastic keepers attaching
the Frame cover, just below the grille, to
the frame.
See Figure 4.
6
Using a Phillips screwdriver, remove
the screws securing thefog lights to the
bumper on the back side. Set fog lights
aside for installation into new bumper.
See Figure 5.
Figure 2
Remove
Figure 3
Remove
Figure 4
Figure 5
Remove
Page 2 of 4
Remove