Rampage 86510 Instrucciones De Instalación página 3

Installation
7
Factory Fog Light Install:
Using the provided 5mm hardware, bolt
the fog lights to the tabs of the light cans
using the top two fog light mounting tabs.
See Figure 6.
8
Rampage Fog Light Install:
Using the hardware provided with the fog
lights, bolt the fog lights to the light can
using the holes in the sides of the light
cans.
See Figure 7.
10
Install your new Recovery Front Bumper
onto the frame of the Jeep.
NOTE: Have someone help lift the bumper
and position it into the correct place for
the studs on the bumper to slide into the
bumper mounting holes on the frame.
See Figure 8.
11
Install the supplied 12mm flange nuts on the studs. Do not fully tighten at this time. Keep
snug and check bumper positioning. Make sure it is level and balanced side to side. Then
tighten hardware.
12
Reconnect Fog Lights if reusing the factory fog lights.
If using Rampage lights, the factory fog light wiring can be used. Custom connection is
necessary. Or use the wiring harness provided with lights to complete install.
Figure 6
Tabs
Figure 7
Side
holes
Figure 8
Page 3 of 4