Warnings And Safety Precautions - Minebea Intec Combics CAIXS2 Advertencias De Instalación Y De Seguridad

3
3
3
3
3
–

Warnings and Safety Precautions

The Combics CAIXS2 indicator complies with the European Council Directives
as well as international regulations and standards for electrical equipment,
electromagnetic compatibility, and the stipulated safety requirements. Improper
use or handling, however, can result in damage and/or injury.
Read these operating instructions carefully before use.
t
This will prevent damage to the equipment.
Please observe safety instructions 65015-750-16 in the safety information
section.
Please also bear the following points in mind:
Make absolutely sure to unplug the indicator from the power before you connect
or disconnect any electronic peripheral devices to or from the interface port.
If you use electrical equipment in installations and under ambient conditions
requiring higher safety standards, you must comply with the provisions as
specified in the applicable regulations for installation in your country.
The operator shall be responsible for any modifications to the equipment and for
any connections of cables or equipment not supplied by Minebea Intec and must
check and, if necessary, correct these modifications and connections.
Warning when using RS-232 cables, purchased from other manufacturers:
These often have incorrect pin assignments for use with Minebea Intec
equipment. Connect only Minebea Intec accessories and options, since these are
optimally designed for use with your device. Therefore, do not use any
proprietary solutions. The operator shall be solely responsible for installation and
testing of any modifications to Minebea Intec equipment, including connection
of cables or equipment not supplied by Minebea Intec. Information on
operational quality (in line with norms pertaining to immunity) is available on
request.
Clean your equipment only as directed in the cleaning instructions (see "Care
and Maintenance").
The display value can be affected by extreme electromagnetic influences. Once
the disturbance has ceased, the instrument can be used again in accordance with
its intended purpose.
Information on operational quality is available upon request from Minebea Intec
(in line with norms pertaining to immunity).
If you have any problems with your device, contact your local Minebea Intec
t
office, dealer or service center.
IP Protection
The model meets the requirements of protection class IP69K.
–
The IP65/IP69k protection rating is ensured only if the rubber gasket is
installed and all connections are fastened securely (including the caps on
unused sockets). Weighing platforms must be installed and tested by a
certified technician.
Warnings and Safety Precautions
Installationsanleitung CAIXS2
3