Connecting The Device To Ac Power; Safety Precautions; Warm-Up Time - Minebea Intec Combics CAIXS2 Advertencias De Instalación Y De Seguridad

Getting Started
10
Installationsanleitung CAIXS2
Re-attach the front panel and tighten the ten cap nuts with a
t
torque of 1 Nm.

Connecting the Device to AC Power

Power is supplied via an external power supply device, which is provided with the
equipment.
3
The power connection must be made in accordance with the regulations
applicable in your country.
Make sure that the voltage rating printed on the manufacturer's ID label is
identical to that of your local mains voltage. If the voltage specified on the label
or the plug design of the AC adapter do not match the rating or standard you
use, please contact your Minebea Intec office or dealer.
Check the voltage rating and plug design.
t
The device must be plugged into a properly installed wall outlet.
t
Protection Class 1 Device
The device must be plugged into a properly installed wall outlet that has
t
a protective grounding conductor (PE).

Safety Precautions

If you use an electrical outlet that does not have a protective grounding
3
conductor, ensure that an equivalent protective conductor is installed by a
certified electrician (as specified in the applicable regulations for installation in
your country). The protective effect must not be negated by using an extension
cord without a protective grounding conductor.
Before using for the first time, any superstructure parts must be completely
installed.
Avoid connecting the equipment to lines that have a heavy electrical load,
e.g. compressors, large machinery, etc.

Warm-Up Time

To deliver exact results, the device must warm up for at least 30 minutes after
connection to AC power. Only after this time will the device have reached the
required operating temperature.