Ryobi ETMS-1426 Manual De Utilización página 17

GB
F D
SAFETY INSTRUCTIONS
Never use the cable for any purpose other than that
■
for which it is intended!
Adopt a firm standing position and keep your balance
■
at all times.
Check the tool for signs of damage!
■
Before you carry on using the tool it is imperative to
■
check that its safety devices and any slightly damaged
parts are working properly and in the way intended.
Check that the moving parts work properly and do not
■
jam or whether any of the parts are damaged.
All parts must be fitted correctly and satisfy all
■
conditions for the tool to work properly.
Unless otherwise stated in these instructions, damaged
■
safety devices and parts must be repaired or replaced
by experts in an approved specialist workshop.
Have damaged switches replaced by an authorized
■
service centre.
This tool complies with the pertinent safety regulations.
■
Repairs are to be carried out only by qualified
electricians using original replacement parts. The user
may suffer an accident if this condition is not observed.
Be careful when working in vertical mode.
■
CAUTION
Special care is required when making compound
mitre cuts.
Do not overload your tool!
■
Wear safety goggles.
■
Wear a breathing mask on dusty jobs.
■
Examine the power cable / extension cable for
■
damage.
Never use damaged or worn blades.
■
Use only blades which are recommended.
■
Be careful when sawing in table saw mode.
■
Table saw mode: Make sure that the saw arm head is
■
securely locked.
Mitre saw mode: Make sure that the upper guard is
■
fully closed.
Mitre saw mode: Make sure that the saw arm head is
■
unlocked when cutting miters.
Wear goggles
Wear ear-muffs
Wear a breathing mask
E I P NL S DK N FIN
English
SPECIFICATION
Input
Power rating
Operating mode
No load speed
Saw blade dimension
Blade type
Connector for dust extractor
Standing area
AS TABLE TOP SAW
Upper saw table
Cutting capacity
Parallel/mitre gauge swinging range
AS MITRE SAW
Bevel range
Mitre cuts
Lower saw table
Cutting capacity
Mitre x Bevel:
0° x 0°
45° L x 0°
0° x 45°
45° L x 45°
DESCRIPTION
1. Release button
2. Handle
3. Switch trigger for mitre saw mode
4. On/Off switch for table top saw mode
5. Saw blade
6. Lower guard, hinged
7. Back fence
8. Mitre table
9. Mitre base
10. Mitre lock knob for turntable
11. Scale
12. Table insert, bottom
13. Guard plate
14. Catch
15. Change over handle
16. Saw table
17. Upper saw blade guard
18. Parallel / Mitre gauge
19. Hexagon wrench
20. Workpiece supports
21. Face wrench
22. Bevel lock lever
23. Retaining pin
25. Plastic knob for mitre table lock
26. Plastic knob for locking stop rail
11
GR H CZ RUS
230 V ~ 50 Hz
1400 W
S1
4000 min
ø 254 x ø 30 x 3,2 mm
40T TCT
ø 39.5 mm
500 x 500 mm
426 x 340 mm
40 mm
-45° to +45°
0° - 45° left
0° to 45° left
475 x 150 mm
70 x 127 mm
70 x 85 mm
38 x 127 mm
35 x 55 mm
RO PL
-1