Installing The Device - Atlantic Tatou Manual De Utilización E Instalación

The device you have just purchased was submitted to many tests and checks ensuring its quality.We
thank you for your choice and trust.We hope you will be fully satisfied.
A few recommendations:
Read the instructions before installing the heater.
Power the heater off before working on it, and check the power supply voltage.
Store the instructionsfor the future reference after installation.
Classification of the heater:
Cat C : Complies with EU standards for this category.
IP24 : Protected against water projections.
Classe II : Dual insulation.
1/ Location of the device
- This heater was designed to be installed in residential
premises. In any ther case, please call your distributor.
- Installation must comply with the standards currently
enforced in the country of use.
- Locate the heater within minimum distances from obs-
tacles.
Do not install the heater:
In a draft likely to affect its control (under
centralised mechanical ventilation, etc...).
Under a fixed mains outlet.
Inside zones 0 and 1 in bathrooms.
The heater is to be installed so that switches and
other controls cannot be touched by a person in
the bath or shower.
In the UK, please refer to the IEE Regulations
601-06-01 and 601-08-01 (BS 7671).
We strongly advise against installing vertical machines above an altitude of 1000m
(risk of faulty operation).
Installing a machine at altitude causes an increase in air output temperature
(of the order of 10°C per 1000m above sea level).
It is forbidden to install a vertical machine horizontally or vice versa.
Do not use the device in mobile, on feets or on casters.
(shown on the information label)
I
NSTALLING THE DEVICE
11
Volume
3
Volume
2
Volume
1